Dual Vertical Masking Stand (VM-2)

The VM-2 holds two masking paper rolls vertically, allowing simultaneous dispensing of two different widths. This eliminates switching between rolls when different coverage widths are needed during a single masking job. Load a narrow width on top and a wide width below for fast access to both.

No. The VM-2 is a freestanding vertical stand that sits on the shop floor. Place it near the spray booth entrance, in the paint prep area, or anywhere masking paper is needed. The freestanding design can be repositioned as shop layout changes without drilling or patching wall holes.

The cutter bar provides a straight-edge cutting point for tearing masking paper cleanly at the desired length. Pull the paper down to the length you need and tear it against the cutter bar. This produces clean, straight edges without scissors or utility knives, speeding up masking work.

The VM-2 accepts standard masking paper rolls used in automotive and industrial paint shops. The dual-roll design holds different widths on each spindle. Contact Creative Coating Solutions with your specific roll width requirements to confirm compatibility with the VM-2 spindle spacing.

The Dual Vertical Masking Stand (VM-2 Masker) is priced at $449.89. It ships in stock from Creative Coating Solutions. Includes the steel frame, dual paper roll spindles, and cutter bar. No wall mounting required for freestanding installation in any shop location.