1/4" 110V Hydraulic Pipe Bender | Baileigh Industrial

The bender runs on standard 110V single-phase power, which is available in virtually every garage, shop, and industrial facility. No 220V or 3-phase wiring upgrade is needed. This makes it one of the most accessible hydraulic benders for small to mid-size fabrication shops starting with pipe bending.

Hydraulic bending uses fluid pressure to apply controlled, consistent force through the full bend arc. This eliminates the physical effort of manual bending on heavier-wall pipe, reduces springback variation, and allows repeatable bends across large batches. The Baileigh hydraulic unit holds position at any degree during the bend.

Die sets determine the tube or pipe OD the bender can form. The unit ships with dies for the primary diameter. Baileigh offers additional die sets for expanding the range. Confirm wall thickness and OD against the die specification before ordering to ensure the hydraulic pressure is within the die's rated capacity.

Yes, with the correct die selection and appropriate pressure settings. Stainless requires more force than mild steel due to its higher work-hardening rate. The hydraulic system provides sufficient pressure for thin-wall stainless. Heavier-wall stainless may require a higher-tonnage model - confirm specifications before ordering.

Baileigh offers square and rectangular tube die sets compatible with this hydraulic unit. Square tube bending requires a mandrel or internal support to prevent wall collapse on the inside of the bend. Confirm the available die sets for your specific tube profile and wall thickness before purchasing.